Can it be done
4 posters
Page 1 of 1
Can it be done
Troy,
I have a Castle Creations 9 turn motor with ESC in a 2WD buggy, can it be transplanted into my honcho, and if so what needs to be doen to strengthen the rig to take it.... I'm just curious as to whether its possible
I have a Castle Creations 9 turn motor with ESC in a 2WD buggy, can it be transplanted into my honcho, and if so what needs to be doen to strengthen the rig to take it.... I'm just curious as to whether its possible
Jayboy74- Posts : 288
Legend Status : 0
Join date : 2011-06-10
Age : 49
Location : Toowoomba
Re: Can it be done
anything is possible Jay
one of the guys up here has a 3.5t in a tamyia cr01, it crawls like #### (but does enough for him to have fun) but is hell funny flying down the beach getting air on every little bump and wicked dough nuts in the sand.
one of the guys up here has a 3.5t in a tamyia cr01, it crawls like #### (but does enough for him to have fun) but is hell funny flying down the beach getting air on every little bump and wicked dough nuts in the sand.
Big fella- Posts : 188
Legend Status : 3
Join date : 2011-02-22
Age : 41
Location : Hervey bay QLD
Re: Can it be done
Big fella wrote:anything is possible Jay
one of the guys up here has a 3.5t in a tamyia cr01, it crawls like #### (but does enough for him to have fun) but is hell funny flying down the beach getting air on every little bump and wicked dough nuts in the sand.
sounds wicked bud , i put a 9t ezyrun combo in the tubed 40 talk about rooster
azwa- Posts : 911
Legend Status : 16
Join date : 2010-11-01
Age : 49
Location : earth
Re: Can it be done
Been there.... Done that... Drifted it.
I did nothing to strengthen mine other than what was done already (so pretty much just tail shafts). It eventually took out the spur gear that was about it if i remember right.
It is an absolute bag of #### to drive, but jeezus is went hard in a straight line.
It's a usless set up for anything other than going fast (and it doesn't do that good of a job doing that compared to some stuff). Because of the design of the motor/esc (sensor-less brushless) it will stutter, cog and have a general hissy fit when you try and go slow, not something you want when you occasionally need to drive a technical section. There is no real way to tune it out of that set-up either.
I did nothing to strengthen mine other than what was done already (so pretty much just tail shafts). It eventually took out the spur gear that was about it if i remember right.
It is an absolute bag of #### to drive, but jeezus is went hard in a straight line.
It's a usless set up for anything other than going fast (and it doesn't do that good of a job doing that compared to some stuff). Because of the design of the motor/esc (sensor-less brushless) it will stutter, cog and have a general hissy fit when you try and go slow, not something you want when you occasionally need to drive a technical section. There is no real way to tune it out of that set-up either.
WIDELOAD- Posts : 655
Legend Status : 40
Join date : 2010-10-26
Age : 37
Location : Ipswich
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|